CELLER8 User Guide

The ‘Morning’ program uses BETA (12-30Hz) frequencies. It will start at 12Hz and increase frequency over time in 1Hz increments until it reaches 30Hz. At 30Hz it will drop down to 12Hz again and the process starts again for the duration of the time set by the user. This program is designed to be used before 12 noon and harnesses higher frequencies in order to maintain alertness.

Many PEMF studies have been completed using a range of these frequencies with such beneficial results on the symptoms of chronic conditions. So rather than limiting the user to one frequency at a time, we are harnessing the benefits of many different frequencies during this program.

The ‘Evening’ program uses ALPHA (8/10Hz) frequencies and allows us to relax and recover at the later part of the day. This program completes one minute of 8Hz, which is closest to the earth’s natural Schumann resonance frequency and then one minute of 10Hz. It will repeat this process every two minutes for the duration of the session.

The 10Hz frequency has also featured in many scientific studies with PEMFs to show huge benefits. NASA also used the 10Hz frequency in a study to promote stem cells for tissue and cell regeneration. The study showing about 400% increase in neural stem cells and turned on about 160 genes that control growth and regeneration. As well as this a German research study also showed that 10Hz is beneficial for stabilising circadian rhythm, assisting in better sleep patterns and negating sleep disturbances.

The ‘Night’ program uses DELTA (1-4Hz) frequencies.the CELLER8 will run 4Hz done to 1Hz with 5-minute intervals. It will repeat this process for as long as you have set the device to run. This mode is pre-set to run for 2 hours (you can set it for longer if you prefer), as this is the perfect time to initiate sleep as well as regulate the DELTA frequencies, assisting us to get the restorative sleep we all deserve.

In ‘Night’ mode, the frequencies are associated with the slowest neurological frequencies and deepest states of relaxation. In deep sleep we do not dream and the mind can really rest, entering the most restorative phases of sleep. 

The ‘Meditation’ mode runs frequencies within the THETA (4-8Hz). The mode will run 8Hz down to 4Hz and then back up to 8Hz again over a period of time. This will continue for the duration of the program length selected, for the user’s ultimate meditation session.

The ‘Meditation’ is there to assist us to really fall into a mediative state of mind. We can experience semi consciousness in really deep meditation and we can use the benefits of PEMF’s to help us get there through THETA frequencies.

The ‘Custom’ mode gives you complete control on what frequency, intensity and duration you can use! You can select any frequency within the range of 0-100 Hz, any intensity within the range of 1-100 gauss on the controller or 1-50 gauss on the mats and adjust the time from 5 minutes to 12 hours.

This mode was only added for those users who want to be very specific with what frequency they want to use and puts you in control. Maybe the user has seen a specific study that was conducted and wants to replicate that study. However, I still believe that the body deserves more than one frequency and to avoid the possibility of your body being accustomed to the same frequency session every time, I recommend that almost every user sticks to the pre-set modes for all desired outcomes.